Tuesday, November 17, 2026

Hanyang University Develops 'Skeleton Stamp' That Cuts Defect Rates in Next-Generation 'MicroLED' by Half

Input
2026-11-16 19:42:36
Updated
2026-11-16 19:42:36
Professor Jeong Ye-hwan (right) and An Seol, a student in the combined master's and doctoral program.
[Financial News] Hanyang University said on the 16th that a research team led by Professor Jeong Ye-hwan of its Department of Convergence Electronic Engineering and a team led by Professor Laudel Avila of Rice University in the U.S. had jointly developed a “skeleton-reinforced hybrid stamp” that reduces the placement error in transferring MicroLED chips, a key component of next-generation displays, by 56% compared with existing methods. The technology is expected to accelerate the commercialization of MicroLED TVs and augmented reality devices, which had been held back by high manufacturing costs, by dramatically lowering the defect rate when tens of millions of tiny chips are transferred onto a substrate.
MicroLEDs are considered a next-generation material for smartwatches, virtual and augmented reality devices, and ultra-large TVs because they are brighter, more power-efficient, and longer-lasting than conventional organic light-emitting diodes. But the “mass-transfer process” of accurately placing tens of millions of chips, each smaller than a grain of sand, in designated positions on a display substrate has been a major obstacle to commercialization. The denser the pixels in a high-resolution screen, the more likely it is that even a few misplaced chips will create defective pixels, making it extremely costly to inspect and repair the entire product.
In the conventional process, chips were picked up and transferred using a micro-stamp made of soft silicone rubber. However, as the stamp pressed down on a chip, the tiny pillars holding it could bend sideways, causing the chip to shift out of position. To solve this problem, the research team devised a dual structure using the same silicone rubber material but with different degrees of stiffness. They embedded a rigid rubber framework inside each tiny pillar to keep it from bending, while covering the outer surface that contacts the chip with soft rubber to maintain the close contact needed to pick up and place chips securely.
In an experiment using an array of tiny pillars on a 4-by-4-centimeter glass substrate, with a resolution of 363 pixels per inch (ppi)—the level of a smartwatch screen—the team found that the average placement error when transferring 100 silicon chips fell by about 56% compared with the existing method. The chips settled into place without wobbling even when the substrate was tilted by about 3 degrees. In a separate test transferring nine actual MicroLED chips in a square array, the team reduced the error to less than 1 μm, around one-hundredth the thickness of a human hair, and confirmed that all the transferred chips lit up normally.
Professor Jeong Ye-hwan said, “We demonstrated that chip-transfer precision can be greatly improved simply by designing the stamp to control how rigid its interior is,” adding, “It will be widely used not only in high-resolution MicroLED displays but also in the manufacture of flexible electronic devices.”
The research was conducted with support from the Ministry of Science and ICT and the Ministry of Trade and Industry. An Seol, a student in Hanyang University's combined master's and doctoral program, and Rice University doctoral student Yulin Zhou served as co-first authors. The findings were published online on the 6th in Advanced Functional Materials, an international journal in the field of materials science.  

[email protected] Kim Man-gi Reporter